Welltech FXS SIP Gateway V.2.9 - Manual (Page 88)

- 76 -
FXS Gateway Overview
Step 1. Set PPPoE mode, using [pppoe]
usr/config$ pppoe –dve 1 (PPPoE used)
usr/config$ pppoe –open (PPPoE open)
Step 2. Input the user id & password provided by your ISP, using [pppoe]
usr/config$ pppoe –id [email protected] (PPPoE login account)
usr/config$ pppoe –pwd 123 (PPPoE login Passowd)
Step 3. Reboot the device once after disconnection, using [pppoe]
usr/config$ pppoe –reboot 1 (Enable)
For example:
usr/config$ pppoe -print
PPPoE adapter information
Device : Enabled
Status : Not initialized
User name : [email protected]
Password : ********
Reboot : Yes
usr/config$
Step 4. Ather the configuration [commit] and [reboot] the device.
usr/config$ commit
usr/config$ reboot
Step 5. When Gateway connection success.
For example:
usr/config$ pppoe -print
PPPoE adapter information
Device : Enabled
Status : Ready
User name : [email protected]
Password : ********
Reboot : Yes
IP address : 218.160.239.35
Destination : 61.223.128.254
DNS primary : 168.95.1.1