Welltech FXS SIP Gateway V.2.9 - Manual (Page 109)

- 97 -
FXS Gateway Overview
-prefix Specify prefix string, use it when UserID contains alphabets
(if UserID uses numerals, specify as null)
-line1 TEL1 Phone number.
-line2 TEL2 Phone number.
-line3 TEL3 Phone number.
-line4 TEL4 Phone number.
-line1s TEL1 Stauts 0:close/1:open.
-line2s TEL2 Stauts 0:close/1:open.
-line3s TEL3 Stauts 0:close/1:open.
-line4s TEL4 Stauts 0:close/1:open.
-pbsearch Search phone book 0:off/1:on.
-ringback Play Local Ringback Tone 0:off/1:on.
-lmedia Late Media 0:off/1:on.
-prack PRovisional ACKnowledgment 0:off/1:on.
-expire The relative time after which the message expires(0 ~ (2^31-1))
-sexpire The session timer(Session-Expires) are used to keep the
session
active(Default: x don't support timer,range:0 ~ (2^31-1))
-minse The minimum session timer(Session-Expires).
(Default: x don't support minimum timer,range:0 ~ (2^31-1))
-port SIP local UDP port number (2326~65534), Default: 5060
-rtp RTP port number (2326~65534), Default: 16384
-useragent User agent set (set x to use the default)
-t1 Retransmission T1 set (default:500)
-t2 Retransmission T2 set (default:4000)
-t4 Retransmission T4 set (default:5000)
-linger General Linger Timer (default:32000)
Example:
sip -mode 1
sip -px 210.59.163.171 -line1 70 -line2 71 -line3 72 -line4 73
usr/config$
Figure 21-28 sip command list
Parameter Usages:
-mode: Configure as Proxy mode or Peer-to-Peer mode (0: Peer-to-Peer mode, 1:
Proxy mode, Gateway Mode).
-px: to specify Proxy address when FXS Gateway is in proxy mode. Proxy address can