Welltech FXS SIP Gateway V.2.9 User Manual
Page 87
- 75 -
FXS Gateway Overview
1
1
UDP
5060
192.168.1.10
5060
V
2
2
UDP
16384
192.168.1.10
16384
V
3
3
UDP
16394
192.168.1.10
16394
V
4
4
UDP
5061
192.168.1.11
5061
V
5
5
UDP
26384
192.168.1.11
26384
V
6
6
UDP
26394
192.168.1.11
26394
V
7
---
0
0
X
8
---
0
0
X
9
---
0
0
X
10
---
0
0
X
Note:
With Dynamic WAN IP Address, when the WAN IP is changed, we need to
change the external IP of FXS Gateway using above command.
1. Different Vendor’s Router will have different appearance of setting.
2. Once you set the DMZ Host, you don’t need to configure the Port Forwarding
and vice versa.
3. If there is only one FXS Gateway attached to the IP Sharing
device, it is recommanded to use DMZ Host setting to enable
the NAT traverse and disable the Port Forwarding.
4. If there are two or more sets of FXS Gateway attached to the
IP-Sharing device, please configure the Port Redirection (Forwarding) to
enable the NAT traverse and disable the DMZ Host.
5. After the IP Sharing configuration of FXS Gateway and IP Sharing device is
complete, you must reboot the FXS Gateway to activate the new settings.
21.4.6 PPPoE
Mode
Figure 21-10 PPPoE Mode