Welltech FXS SIP Gateway V.2.9 User Manual
Page 84
- 72 -
FXS Gateway Overview
Step 1. Create a Hotline table with [line] command.
usr/config$ line –hotline 1 10.2.2.2 201
This example means that if user picks up phone set of FXS Line1, gateway will
automatically dial out IP address of [201].
Note:
The IP address of “line -hotline” command indicates the IP address and number
of called party in P2P mode, or the proxy IP address in proxy mode.
Step 2.
After the configuration, [commit] and [reboot] the device.
usr/config$ commit
usr/config$ reboot
21.4.5
Behind IP-Sharing Mode
One Sets FXS Gateway
The function is for user whose network environment is behind IP Sharing device.
It is said Gateway is connected to the IP Sharing device.
An example such as ADSL network is in the following.
Figure 21-8 One Sets FXS Gateway
Step 1. The WAN IP Address obtained from ADSL has two kinds of methods. One is
fixed IP Address, while user applies for one or more fixed IP Addresses. Another
is dynamic IP Address while user applies for dial-up connection way.
Step 2. The LAN IP Address of User’s PC can be set as DHCP client in order to gain
a valid one.