Welltech FXS SIP Gateway V.2.9 - Manual (Page 93)

- 81 -
FXS Gateway Overview
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):
For example:
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):0001a8002743
- the mac address is 00 01 a8 00 27 43
- if mac address is correct,please press 'y' to
setup configuration,else press 'n' to continue
y
- mac address configuraton OK.
usr/config$
Step 5. Set IP Address:
usr/config$ ifaddr –ip xxx.xxx.xxx.xxx –mask xxx.xxx.xxx.xxx –gate
xxx.xxx.xxx.xxx
Step 6. commit, reboot
usr/config$ commit
usr/config$ reboot
21.6 Commands with FXS Gateway
The following table lists all of the commands that you can use with the Gateway.
Refer to the following chapters for descriptions of commonly used commands.
This user’s guide describes commands that are helpful for configuring the
Gateway. Using commands not documented in the user’s guide can damage the
unit and possibly render it unusable.
Table 21-1 Commands with FXS Gateway
Command DESCRIPTION
help help/man/?[command]
quit quit/exit/close.
debug Show debug message.
reboot Reboot local machine.
flash Clean configuration from flash rom.
commit Commit flash rom data.
ifaddr Internet address manipulation.
time Show current time.
ping Test that a remote host is reachable.