Welltech FXS SIP Gateway V.2.9 - Manual (Page 106)

- 94 -
FXS Gateway Overview
-userphone Add user=phone parameter in the SIP message (ON:1/OFF:0)
-billing Billing Mode(0:None/1:Reverse/2:Tone/3:F12K/4:F16K)
-bmod Billing Method Mode(0:Only Once/1:Repeat)
-transfer Transfer Mode(0:Disable/1:Enable)
-mwi Enable the MWI subscription function
(0: OFF, 1: Client(Subscribe),2: Proxy(NOTIFY))
-mwiexpires MWI Subscription Keep Alive for Client(default:1800 sec)
-mwinumber Voice MailBox Number
-autosiport SIP port assigning manner(0:Disable/1:Enable)
-snumber When dial this number it will use G.711A codec only.
-waiting Enable the Call Waiting function(0: OFF, 1: ON)
-ptime Include the ptime parame(0: OFF, 1: ON)
Example:
sysconf -keypad 0 -eod 2 -callerid 1
sysconf –duration 160
usr/config$
Figure 21-26 sysconf command list
Parameter Usages:
-print: Print current sysconf settings.
-idtime: Set the duration (in second) of two pressed digits in dial mode as timed out. If
after the duration user hasn’t pressed next number, it will dial out all number
pressed (1-10 seconds).
-bf: Only working in Proxy mode and Peer-to-Peer mode (some previous version does
not support in Peer-to-Peer mode). If the line1 is engaged as well as this
function is enabled, the line2 will be ringing.
-keypad: DTMF replay type. When value is “1”, FXS Gateway will transfer DTMF
signal via RTP payload as defined in RFC2833. When the value is set to “0”,
the DTMF type is set as In-band, and set 2 for SIP info method.
-faxtype: FAX Payload Type. Rrange:96~128 inter-used:100,102~105.
-2833type: RFC2833 Payload Type. Range: 96~128 inter-used: 100, 102~105.
-lcdrop: Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime: Period of Loop Current Drop (ms).
-duration : setup flash send SIP info value, default 160.
-eod: It will transfer the DTMF in [#] if users disable the end of dial function. Users
have to press the keypad in [#] if the end of dial function is enabled.