Watson-Marlow MM440 User Manual
Page 54
3 Functions
Issue 10/06
MICROMASTER 440 Operating Instructions
54
6SE6400-5AW00-0BP0
Attribute
group
Attribute Description
The parameters are sub-divided into groups according to their functionality. This
increases the transparency and allows a parameter to be quickly searched for.
Furthermore, parameter P0004 can be used to control the ability to be visualized for
the BOP / AOP.
Main
parameter
area:
ALWAYS 0
all
parameters
INVERTER
2 drive inverter parameters
0200 .... 0299
MOTOR
3 motor parameters
0300 .... 0399 and
0600 .... 0699
ENCODER
4 speed encoder
0400 .... 0499
TECH_APL
5 technical applications / units
0500 .... 0599
COMMANDS 7 control commands, digital I/O
0700 .... 0749 and
0800 .... 0899
TERMINAL
8 Analog inputs/outputs
0750 .... 0799
SETPOINT
10 Setpoint channel and ramp-function gen.
1000 .... 1199
FUNC
12 Drive inverter functions
1200 .... 1299
CONTROL
13 Motor open-loop/closed-loop control
1300 .... 1799
COMM
20 Communications
2000 .... 2099
ALARMS 21
Faults,
warnings,
monitoring functions"
2100 .... 2199
Grouping
TECH 22
Technological
controller (PID controller)
2200 .... 2399
Description for Binector Input (BI), Binector Output (BO), Connector Input (CI),
Connector Output (CO) and Connector Output / Binector Output (CO/BO), refer to
Section 3.1.2.3
BI Binector
Input
BO Binector
Output
CI Connector
Input
CO Connector
Output
BICO
CO/BO
Connector Output / Binector Output
Description for the command data set (CDS) and drive data set (DDS) refer to Section
3.1.3
CDS
Command data set
Data sets
DDS
Drive data set
"P" parameters can only be changed depending on the drive state. The parameter
value is not accepted if the instantaneous state is not listed in the parameter attribute
"Change state". For instance, the commissioning (start-up) parameter P0010 with the
attribute "CT" can only be changed in quick start-up "C" or ready "T" but not in run
"U".
C
Quick commissioning (start-up)
U Operation
(run)
Change state
T Ready
This parameter attribute identifies as to whether the parameter is included in the quick
commissioning (start-up) (P0010 = 1).
No
The parameter is not included in the quick commissioning (start-up)
QC.
Yes
The parameter is included in the quick commissioning (start-up)
This attribute is only of importance in conjunction with a BOP. The "Immediate"
attribute indicates that this value is already accepted when scrolling (when changing
the value with
or
). Especially parameters which are used for optimization
functions have this property (e.g. constant voltage boost P1310 or filter time
constants). On the other hand, for parameters with the attribute "After actuation", the
value is only accepted after first actuating the key
. These include, for example,
parameters where the parameter value can have different settings/meanings (e.g.
selecting the frequency setpoint source P1000).
Immediately The value becomes valid by either scrolling with
or
Active
After
actuation
The value is only accepted by pressing