Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 92)

4-18 F r a m e S t a r t F S M
from the column, or to a Type Details screen from the
column.
Figure 4.13 Service Details Screen
From this screen, you can access and change the parameters listed below. The
new parameters are saved when you press the “Esc” key and return to the
previous screen.
Interface Selecting one of the interfaces will bring up a screen where you can view
interface parameters. These screens are the same ones displayed when you
select a sub-menu from the Interfaces menu described earlier on page 4-6.
Type Selecting one of the services listed under the “Type” column will bring up a
screen where you can view (and, in some cases, change) parameters for each
type of service. The details displayed depend on the type of service (TDM,
PPP, Frame Relay, IP, or tty) currently in effect. These screens are shown and
described below according to each type of service.
Pair User-assigned integer field that specifies where to route the traffic from this
service. If the service is terminated by the unit, set this value to “0” (zero).
Channel Table Details Screen
To access the Channel Table Details screen (Figure 4.14), select “TDM” from
the Service Table. This screen displays a channel map for the Network
services, but does not display a sub-menu for Serial services.