Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 106)

4-32 F r a m e S t a r t F S M
Remote IP Address If this FrameStart FSM unit is to be used to manage a remote FSM unit, you
must configure the IP address of the remote FSM unit here. This DLCI can be
used for management only, or for management and actual data.
If this parameter is set, a PC connected to the LAN interface of this
FrameStart FSM can reach a remote FSM through this DLCI. The remote IP
address must be part of an IP network that is different from the local FSM,
and the local FSM's IP address must be configured into the PC. This way,
local and remote FSMs can be reached regardless of the availability of the
routers connected at the back of the FSMs.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
Delete Endpoint You may delete any endpoint.
Endpoint Service Details Screen
Selecting from the column on the Endpoint Table screen displays the
typical Service Details screen (page 4-18) in which you can view, and in some
cases change, parameters including Index, Interface, Type, and Pair. A
“Delete Service” prompt is also included on this screen.
DLCI Details Screen
The DLCI Details screen (Figure 4.25) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
select any DLCI from the column on the Endpoint Table screen.