Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 28)

3-4 F r a m e S t a r t F S M
Figure 3.2 Maintenance Reset Screen
NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit. “Refresh” after approximately
10 seconds to restore communications.
Save and Restart Use this button to save the current configuration settings and proceed with the
restart as shown in Figure 3.3.
Figure 3.3 Save and Restart Screen
Interfaces
The FSM has the following interfaces: Network, Serial, 10/100 Ethernet, and
Supervisory. Each of the interfaces and their associated screens/menus are
described below.
Network Screen
The Network screen (Figure 3.4) lets you view and make changes to the
Network interface's configuration as described below. In addition, this screen
provides a table that displays the alarm values for the Network interface.