Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 16)

1-4 F r a m e S t a r t F S M
Figure 1.1 Front Panel of FrameStart FSM
The front panel LED status indicators are defined in the table below:
Indicator Description
NET This indicator is off (not illuminated) when the port has not
been configured.
The indicator lights green when the T1 link is up and all
configured protocol services are established.
The indicator lights red if the T1 link is down and the
configured protocol is not established.
The indicator lights amber
if the T1 link is up and at least one
configured protocol is not established.
SERIAL DTR Alarm Enabled:
This indicator is off (not illuminated) when the port has not
been configured.
The indicator lights green when DTR is active and the
configured protocol is established.
The indicator lights red when DTR is not active and the
configured protocol is not established.
The indicator lights amber when DTR is not active or the
configured protocol is not established.
DTR Alarm Disabled:
This indicator is off (not illuminated) when the port has not
been configured.
The indicator lights green when the configured protocol is
established.
The indicator lights red when the configured protocol is not
established.
ALARM This indicator lights red if an alarm condition exists
The indicator lights amber if a “yellow” alarm condition exists.
POWER This indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (Port looped or BERT
active).