Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 64)

3-40 F r a m e S t a r t F S M
Figure 3.27 DLCI Table Screen
NOTICE: The DLCI Table and DLCI Details screens are available from the both
the Endpoint Table and the Frame Relay Service Details screens.
SNMP Details Screen
The unit detects and reports T1 network alarms and provides several options
for reporting them, one of which is SNMP traps. When a network alarm
occurs, the unit sends a trap message to as many as eight destinations on your
network. The unit will report each alarm by transmitting an SNMP “trap” to
each non-zero Trap IP address. The SNMP Details screen (Figure 3.28) lets
you configure the SNMP parameters described in the paragraphs below.
Figure 3.28 SNMP Details Screen
Read Community Accepts a character string identifying the group authorized to perform read
operations. The default setting is “Public.”
Write Community Accepts a character string identifying the group authorized to perform write
operations. The default setting is “Private.”
Trap Community Accepts a character string, which is included in SNMP traps generated by the
unit. The default setting is “Public.”