Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 56)

3-32 F r a m e S t a r t F S M
Endpoint Table Screen
The Endpoint Table (Figure 3.23) describes all endpoints terminating in the
unit; user-activated buttons are provided to view the Endpoint Details,
Endpoint Service Details, and Endpoint DLCI Details screens. The unit will
automatically learn all DLCIs from the Network side and relay that
information on the Serial side with default values.
The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has been
changed and submitted in the Endpoint Details screen (page 3-33).
NOTICE: The Endpoint Table and its corresponding DLCIs will be saved in the
configuration database only after at least one endpoint parameter has
been changed and submitted in the Endpoint Details Screen on
page 3-33.
NOTICE: Endpoint names of the form PPP-Sn are reserved by the system. These
system-generated endpoints cannot be modified.
Figure 3.23 Endpoint Table Screen
For most applications, the Endpoint Table and DLCI Table will not have to be
modified. Modification would be necessary, however, to configure remote in-
band management. (See In Band management on page 3-36.)
Endpoint Details Screen
The Endpoint Details screen (Figure 3.24) provides you with access to the
configuration parameters described in the paragraphs below.