Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 57)

W e b S e r v e r I n t e r f a c e 3-33
Figure 3.24 Endpoint Details Screen
Name When the unit learns a new DLCI, it creates an endpoint entry and a DLCI
entry if they are not already configured. The endpoint’s Name will
automatically be assigned as “Dynamic”; however, this name can (and most
likely should) be changed to reflect a remote location name. Submitting a
changed Name parameter will cause the endpoint entry and its corresponding
DLCI entry to be saved in the configuration database.
Value: A string of up to 11 characters
Default: None
CAUTION: When configuring endpoints, the name you assign each endpoint in
the Name parameter field must be unique within the unit.
Service The Service Index number (from the Service Table) on which this DLCI was
found or configured.
Values: Displays the currently active Services (by index number) or the
Service(s) on which the DLCI was discovered.
Default: 0
DLCI The DLCI number.
Values: 0–1023
Default: 0
Forward Endpoint By default, each DLCI is switched to its pair service in the Service Table
using the same DLCI number. If this endpoint has to be switched to a
different DLCI or a different service, the endpoint index of the destination
must be configured here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0