Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 129)

F r o n t P a n e l L C D I n t e r f a c e 5-11
Length Lets you specify the length of time that the BERT should run for the selected
interface.
Values: 15 Minutes, 30 Minutes, 1 Hour, 24 Hours, Continuous
Default: 15 Minutes
Sync Display-only field shows the state of pattern sync during a BERT. If no
BERT is in progress, “No Test” is displayed. If a BERT is active but the
receiver is not in pattern sync, “No Sync” is displayed. If the receiver is in
pattern sync, “In Sync” is displayed.
Elapsed Display-only field shows the amount of time (in seconds) that has elapsed
since a BERT began or, if completed, the total test time.
Bit Errors This display-only field shows the number of bit errors detected since the
BERT began or since error statistics were last cleared.
ES Display-only field shows the number of asynchronous errored seconds
detected since the BERT began or since error statistics were last cleared. This
parameter includes bit error seconds and sync loss seconds.
% EFS Display-only field shows what percent of the total test time ran error free.
This ratio is derived from the number of error free seconds divided by the
number of seconds accumulated in Elapsed Time.
Cmd Lets you control basic aspects of the BERT performed, including the injection
of errors during test.
Values: Stop, Reset, Error Inject, Start
Default: Stop
Configuration Menu
The Configuration menu lets you configure the parameters of the various
interfaces.
Figure 5.10 Configuration Menu Tree
TCP/IP Configuration Menu
The TCP/IP CONFIG menu lets you configure the unit’s IP parameters. Use
the
SCROLL button to display the desired configuration parameter, and then
press the SELECT button to activate the configuration function.
Configuration
Serial Config Net Config TCP/IP Config Supv Config