Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 91)

V T 1 0 0 I n t e r f a c e 4-17
Parity Sets the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alarm Control Lets you set DTR Alarm Control parameters.
Values: Enable, Disable
Default: Disable
DTR Alarm Status Lets you view the current DTR Alarm status.
Diagnostic Messages Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory Config screen.
Service Table Screen
The Service Table screen (Figure 4.12) provides a view of the unit’s defined
services and displays the Interface, Type, and Pair parameters for each
service.
Figure 4.12 Service Table Screen
The Service Table screen displays the available services listed by Index
number. From the Service Table screen, you can navigate to a Service Details
screen (Figure 4.13) from the column, to an Interface Details screen