Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 29)

W e b S e r v e r I n t e r f a c e 3-5
Figure 3.4 Network Screen
Mode Selects the network service type.
Values: Long Haul, Short Haul
Default: Long Haul
Line Build-Out (Long
Haul)
Sets the transmit Line Build Out (LBO) for the Long-Haul network interface.
Values: 0,
−
7.5,
−
15.0,
−
22.5 dB
Default: 0 dB
DSX Level (Short
Haul)
Specifies the DTE DSX-1 interface output level.
Values: 0
−
110, 111
−
220, 221
−
330, 331
−
440, 441
−
550, 551
−
660, >661 ft
Default: 0
−110
ft
Framing Selects the framing for the network side of the DSU/ CSU.
Values ESF, D4
Default: ESF
Coding Sets the network side line coding.
Values: AMI, B8ZS
Default: B8ZS
Timing Sets the timing source to synchronize the unit’s internal timing generators. In
all cases, slips are controlled to occur on frame boundaries at the Network
port when timing synchronization is lost. Choices are as follows:
Internal
−
The unit’s internal frequency standard is used for all timing.
Network
−
Timing is derived from the network recovered clock. (Most
applications use this selection.)