Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 47)

W e b S e r v e r I n t e r f a c e 3-23
Status and Alarms Table
The table displayed at the bottom of the Frame Relay Service Details screen
reports on the status and condition of LMI parameters and on Receive/
Transmit alarms and thresholds. Alarm threshold levels may be changed by
entering a new threshold value in the appropriate field of the table and
clicking the “Submit” button. Table fields are describe below.
Active Read-only field shows whether or not (No or Yes) an alarm is active.
LMI Type Read-only status indicates ANSI, CCITT, LMI rev. 1, or Unknown.
FrameStart Status Read-only status indicates Sourcing, Monitoring, or 0.
Rx Invalid Threshold Number of invalid frames received during a 15-minute interval after which an
invalid alarm will be triggered. Default of “0” disables this alarm.
Rx Invalid Alarm Status of this alarm indicates OK or Alarmed.
Tx Threshold Number of bits per second sent during a 15-minute interval after which a Tx
alarm will be triggered. Default of 0 disables this alarm.
Tx Alarm Status of this alarm indicates OK or Alarmed.
Rx Threshold Number of bits per second sent during a 15-minute interval after which an Rx
alarm will be triggered. Default of 0 disables this alarm.
Rx Alarm Status of this alarm indicates OK or Alarmed.
The Frame Relay Details screen provides the following user-activated buttons:
NOTICE: When a “Submit” command is executed, the frame relay link will be re-
initialized with the new parameters, causing a brief interruption in data
transfer.
Button Function
Submit Sets any values that have been changed.
Frame Relay Statistics Opens the Frame Relay Port Statistics screen for the current
Frame Relay service.
DLCI Table Opens the DLCI Table screen which displays all the DLCIs
on the current service. Refer to DLCI Table Screen on
page 3-40 for more information.
Clear Alarms Clears all Frame Relay alarms.
Pair Type Details Opens another Frame Relay Service Details screen that
reverses the service and the pair so that you can view both
sides of the pair.
Refresh Refreshes data on the current page.