Verilink FrameStart FSM (34-00299.E) Product Manual - Manual (Page 41)

W e b S e r v e r I n t e r f a c e 3-17
The table in the center of the screen displays the available services listed by
index number. To view more detailed information about a service, click on
the index number associated with the desired service on the above screen and
then click on one of the user-activated “Details” buttons on the Service
Details screen as described below. A “Refresh” button is also provided on the
Services screen.
NOTICE: Any changes to settings in the Service Table require a “Save and
Restart” for them to take effect.
Service Details Screen
Clicking on an index number under the “Service Index” column on the
Services screen will display a Service Details screen such as the one shown
below (Figure 3.13) (In this example, the selected service type is Frame
Relay.)
Figure 3.13 Service Details Screen
The Service Details screen lets you change the parameters below for each
service:
* PPP is the only service that may be attached to the Virtual interface. You would choose the
Virtual interface for PPP if you elected to run PPP over Frame Relay. When you attach PPP to
the Virtual interface, you must supply an endpoint over which to send PPP encapsulated data,
and that endpoint must be for a Frame Relay DLCI.
Parameter Options
Interface Unassigned, Supervisory, Network, Serial, 10/100 Ethernet,
Virtual*
Type TDM, PPP, Frame Relay, IP, tty
Pair User-assigned integer field that specifies where to route the traffic
from this Service. If the Service is terminated by the unit, set this
value to “0” (zero).