Teac GigaStudio 4 - Manual (Page 111)

GigaStudio 4 Reference Manual 111
Loop Section
The Loop section has controls for loop start and loop end.
As with sample start, there are also small arrow markers superimposed on the waveform that show loop
points. The loop start marker is a green arrow that points to the right, while the loop end marker is a red
arrow that points to the left. You can drag these markers to set loop start and end points.
Note: Enabling and disabling of loop points can only be done using the GS4 Editor application.
Loop Start (0 to end of file, in samples)
This sets the loop start point. However, note the following fine points:
•
Remember that holding down the Shift key while varying this knob allows fine-tuning.
• When using the loop start control to set the loop start, it will “jump” to an appropriate place that will
increase the odds of creating a seamless loop. If you need finer control, drag the marker.
• If a loop is established with a start and end point, moving the Loop Start control will cause the Loop End
control to move in tandem so that the loop length is always preserved. Moving the Loop Start marker will
not cause the Loop End marker to move.