Teac DP-32 - Manual (Page 72)

72
TASCAM DP-32
11 - Various Other Functions
PREFERENCE menu settings
Use the
PREFERENCE
menu to change various
settings to optimize the unit for your use conditions and
requirements, as well as to restore the factory settings.
Follow these steps to open the
PREFERENCE
menu.
1. When the recorder is stopped, press the MENU
button to open the
MENU
screen.
2. Use the JOG/DATA dial or the CURSOR (5/b/g/
t ) buttons to select
PREFERENCE
, and then press
the F4 (t) button.
The
PREFERENCE
screen opens.
3. On the
PREFERENCE
screen, use the CURSOR
(5/b) buttons to select a parameter, and then use
the JOG/DATA dial to change its setting.
Menu item Function Reference
Auto Power
Save Set automatic power
saving
Page 72
Contrast Adjust display contrast
Page 34 Brightness Adjust display brightness
Backlight Adjust display backlight
Foot SW
Right Set right footswitch pedal
assignment
Page 49
Foot SW
Center Set center footswitch
pedal assignment
Foot SW
Left Set left footswitch pedal
assignment
Undo
History
Set length of undo history Page 47
Jump Back Set jumpback time Page 53
Auto
Monitor
Set automatic monitoring Page 72
Preview
Time Set preview playback
time
Page 54
Peak Hold Set peak hold time Page 43
Song Name
Type
Set file name format Page 72
Date/Time Set date and time Page 33
Initialize Restore default settings Page 73
Setting automatic power saving
Use the
Auto Power Save
item to set the amount
of time until the unit power turns off after the last user
operation or function completes.
The options and default value are as follows.
Options: OFF, 3 min, 5 min, 10 min, 30 min
(default)
NOTE
The Auto Power Save function is disabled under the following
conditions.
(1) During recording or playback
(2) When the metronome is in use
(3) When the record function is ON
(4) When a signal is output from the STEREO OUT
Setting automatic monitoring
Input monitoring is possible when recording is enabled
and the transport is stopped.
If automatic monitoring is ON, when playback starts,
input sounds are muted, and only playback sounds can be
monitored.
Use the
AUTO MONITOR item to set this function.
OFF (default):
Input sounds are not muted even when playback starts.
When recording is enabled, input and playback sounds
are mixed.
ON:
When playback starts, input sounds are muted.
When recording is enabled, only playback sounds can
be heard.
Setting the song name format
Use the
Song Name Type
item to set the format used
for song names created by this unit to WORD (default) or
DATE
.
WORD: The characters set are used for the
beginning of the song name.
Example (set to "TASCAM"):
"TASCAM0001"
DATE:
The date is used for the beginning of
the song name.
Example (created on July 10, 2012):
"201207100001"
ª Setting the WORD
When the Song Name Type on the PREFERENCE
screen is set to
WORD
, press the F4 [
t
] button to open
the setting screen.
The length of the word is limited to XX single-byte
alphanumeric characters. (See "Editing names" on page
35.)