Teac DP-32 - Manual (Page 58)

58
TASCAM DP-32
8 - Track Editing
ª IN/OUT/TO
To change the IN/OUT/TO points, exit the TRACK EDIT
screen, and set them again as necessary.
ª TARGET Track
This is the track that is edited. In the case of OPEN, CUT,
SILENCE and CLEAN OUT, the source track itself is the target
track.
The options depend on what you have set for the
SOURCE track .
When the
SOURCE track
is
ALL
(all tracks) , the
TARGET track must also be ALL (all tracks).
ª TIMES
Set the number of times that the copied section will be
pasted between
1
and
99
.
COPY/PASTE
IN OUT TO
IN OUT TO
This function copies the audio data from between the IN
and OUT points on the source track, and pastes it on the
target track starting from the TO point. This operation
does not change the source track between the IN and
OUT points.
This operation overwrites recorded data on the target
track. Therefore, the length of the target track is not
changed.
You can make multiple copies in a single operation.
In other words, you can overwrite the target track from
the TO point with a designated number of repetitions of
the source data.
The following parameters are used in this operation.
• SOURCE Track
• IN/OUT/TO
• TARGET
• TIMES
COPY/INSERT
IN OUT TO
IN OUT TO
This function copies the audio data from between the IN
and OUT points on the source track, and inserts it on the
target track starting from the TO point. This operation
does not change the source track between the IN and
OUT points.
This operation inserts recorded data into the target track.
The recorded data on the target track after the TO point is
offset by the amount of time used by the inserted audio
data. Therefore, the target track becomes longer.
You can make multiple copies in a single operation. In
other words, you can insert a designated number of
repetitions of the data into the target track from the TO
point.
The following parameters are used in this operation.
• SOURCE Track
• IN/OUT/TO
• TARGET
• TIMES