Teac DP-32 - Manual (Page 57)

TASCAM DP-32
57
8 - Track Editing
In the past, editing recordings made on tape recorders
required advanced techniques, but with this unit editing
is easy and accurate.
Moreover, unlike with a tape recorder when an editing
error could not be undone, this unit uses non-destructive
editing, which means you can edit without altering the
original data so the undo function can be used to correct
an edit easily. (See "Undoing an operation" on page 47.)
Overview of track editing
This unit has the following track editing functions.
• COPY/PASTE
• COPY/INSERT
• MOVE/PASTE
• MOVE/INSERT
• OPEN (insert silence)
• CUT (remove part)
• SILENCE (erase part)
• CLONE TRACK (duplicate track)
• CLEAN OUT (delete track)
Editing points
The IN, OUT and TO points are used as editing points for
the COPY/PASTE, COPY/ INSERT, MOVE/PASTE and MOVE/
INSERT functions.
The IN and OUT points are used as editing points for the
OPEN, CUT, and SILENCE functions.
These are the same IN and OUT points used for repeat
playback.
ª IN point
The IN point is the start point for the part of the track to
be edited.
Press and hold the MARK SET button and press the IN
button to set the IN point at the current position.
ª OUT point
The OUT point is the end point for the part of the track to
be edited.
Press and hold the MARK SET button and press the OUT
button to set the OUT point at the current position.
ª TO point
The TO point is the current playback position.
NOTE
If you press the JOG PLAY button to enable jog mode, you
can set IN and OUT points with subframe (1/10 frame)
precision.
Basic editing procedures
1. When the recorder is stopped, press the TRACK
EDIT button to open the
TRACK EDIT
menu.
2. Use the JOG/DATA dial or the CURSOR (5/b)
buttons to select (highlight blue) the desired track
editing function, and then press the F4 (t) button.
The corresponding function window opens.
COPY PASTE window
3. Select the setting item value.
If there are multiple setting items, use the CURSOR
(5/b) buttons to select one, and then use the JOG/
DATA dial to set the value.
4. Press the F2 (
YES
) button to execute the function.
NOTE
Press the F1 (
NO
) button to close the
COPY PASTE
window
without executing the function.
Explanation of items
ª SOURCE
This is the track to be edited.
The choices available depend on the editing function.
•
1
to
12
: Single track
• 13/14
to
31/32
: Stereo track
You can also use track SELECT buttons to set this.
• ALL
: Every track from 1 to 32
COPY PASTE window