Teac DP-32 - Manual (Page 12)

12
TASCAM DP-32
2 - Quick Guide
CAUTION
• Do not remove or insert an SD card when the power
is ON. Always turn the power off (put in standby)
before removing or inserting an SD card.
• When the power is ON, do not disconnect the power
cord or otherwise interrupt the power to the unit.
Doing so will cause all settings made since the last
time you saved to be lost. If the power is interrupted
while an SD card is being accessed, all recorded songs
and data on the card could be damaged beyond
recovery.
• Before turning the power ON, minimize the
headphones volume and the volume on any
monitoring system connected to this unit.
TIP
By connecting an amplifier or powered speakers to the
MONITOR OUT jacks, you can monitor using speakers.
Listening to the demo song
The included SD card in the unit contains a demo song.
We will use this demo song to practice listening to and
mixing a recording.
1. Press the HOME button to open the Home screen.
2. When the recorder is stopped, press the MENU
button to open the
MENU
screen.
3. Use the JOG/DATA dial or the CURSOR (5/b/g/t)
buttons to select (highlight green)
SONG
, and then
press the F4 (t) button.
The
SONG LIST
screen opens.
4. Use the JOG/DATA dial or the CURSOR (5/b)
buttons to select
DEMO SONG
, and then press the
F4 (t) button to open a menu list.
5. Use the JOG/DATA dial or the CURSOR (5/b)
buttons to select
LOAD
, and then press the F4 (t)
button.
The
SONG LOAD pop-up window appears.
6. Press the F2 (
YES
) button to load the demo song.
The demo song is loaded and the window closes, but
the
SONG LIST
screen remains open.
7. Press the HOME button to return to the Home
screen.
8. Press the PLAY (7) button, and raise the levels of
the track and STEREO faders and the MONITOR
LEVEL knob to listen to the demo song.
The STEREO fader adjusts the overall volume of the
mixer output. When the STEREO fader is at 0dB the
overall level is neither increased nor decreased.
Use the track faders to adjust the balance of the tracks.
Use the MONITOR LEVEL knob to adjust the final
monitoring volume.
9. Press the MIXER button to open the
Mixer
screen.
10. Press a SOURCE buttons to select an input (A-H) or
press a SELECT button to select a track to be set.
Then use the PAN knob to set the stereo position
of that input or track. Repeat for other inputs and
tracks.