Teac DP-32 - Manual (Page 54)

54
TASCAM DP-32
7 - Recorder Functions
Previewing cue points
You can preview playback to check whether it is cued
correctly. This function can be used to preview audio both
before and after the current playback position.
1. When the recorder is stopped, press the MENU
button to open the
MENU
screen.
2. Use the JOG/DATA dial or the CURSOR (5/b/g/t)
buttons to select (highlight green)
PREFERENCE
,
and then press the F4 (t) button.
The
PREFERENCE
screen opens.
3. Use the CURSOR (5/b) buttons to select (highlight
blue)
Preview Time
, then use the JOG/DATA dial
to set the preview playback time.
Preview Time:
1 Sec
to
10 Sec
(default:
4 Sec
)
4. After making the setting, press the HOME button
to return to the Home screen.
5. Preview playback before or after the cue point.
To preview after the cue point:
While playback is stopped, hold the PREVIEW button
and press the OUT button to play from the current
point for the preview time, and then return to the
current point and stop.
To preview before the cue point:
While playback is stopped, hold the PREVIEW button
and press the IN button to skip back the preview time
and then play to the current time and stop.
Automatic punching in and out
You can use the punch in/out function to automatically
record between punch-in and punch-out points set in
advance.
When using auto punch in/out recording, playback starts
from the pre-roll point before the punch-in point where
recording starts. Once the punch-out point is reached,
recording ends, but playback continues for the post-roll
time and then stops.
In automatic punch in/out recording, monitoring of the
recording tracks changes as follows.
• Pre-roll period: Track playback signal + input source
signal
• Punch in–out interval: Input source signal
• Post-roll period: Track playback signal + input source
signal
Tracks not armed for recording can be monitored the
entire time.
When using this auto punch in/out function, the above
monitoring changes occur not only during actual
recording, but also in the Rehearsal mode.
In Rehearsal mode, you can simulate auto punch in/out
recording, so you can rehearse your performance and also
check whether the IN and OUT points are set correctly.
You can also use punch in/out in with the repeat function.
By using these functions together, you can repeatedly
rehearse punch in/out recording, or record multiple takes
of the same section, letting the unit work automatically.
After recording multiple takes, you can choose the best
one.
Setting punch-in/out points
There are two ways to set the punch-in/out points.
LAST REC:
This option sets the starting and ending points of the
last recording (or rehearsal) as the punch in and out
points.
IN - OUT:
This option sets the IN and OUT points as the punch-in/
out points. The first of these points will be used as the
punch-in point and the second as the punch-out point.
1. When the recorder is stopped, press the HOME
button to open the Home screen.
2. Press the REC button for the track(s) on which you
want to automatically punch in and out.
3. Press the AUTO PUNCH button to open the
AUTO PUNCH
screen.
4. Use the CURSOR (5/b) buttons to select (highlight
blue)
MODE
,
PREROLL
or
POSTROLL
, and then
use the JOG/DATA dial to set the value.
MODE
:
LAST REC
or
IN-OUT
PREROLL : 1.0 to 9.9 sec
POSTROLL : 1.0 to 9.9 sec
After setting
MODE
,
PREROLL
and
POSTROLL
,
press the F4 (t) button to return to the Home screen.