Teac DP-32 - Manual (Page 61)

TASCAM DP-32
61
9 - Using Internal Effects
This chapter explains the dynamic effects, guitar effects,
and send effects that can be applied to individual mic and
guitar inputs.
You can select one of four types of dynamic effects
(COMPRESSOR, NOISE SUPPRESSOR, DE-ESSER, EXCITER)
for use with all inputs (A to H).
For details about the parameters of each type of effect,
see "18 - Appendix" (page 97).
The library settings of guitar and send effects can be used
for other songs.
Even when parameter settings are not stored in the
library, effect assignments and parameters are always
stored as part of a song.
Dynamic effects
When you press the DYNAMICS button, the inserted effect
for the last selected input (INPUT A to H) is displayed.
You can select one of the four types of effects
(COMPRESSOR, NOISE SUPPRESSOR, DE-ESSER, EXCITER)
and apply it to all inputs (A to H) (simultaneous
application has some limitations).
You cannot use multiple types of dynamic effects
simultaneously.
CAUTION
When using a guitar effect together with a dynamic
effect, the dynamic effect can be inserted on a
maximum of 2 channels.
The selected input (A to H) and on/off state are shown on
the screen.
Inserting a dynamic effect
Press the DYNAMICS button to open the
DYNAMICS
screen. Press the SOURCE button to select the input (A to
H) where you want to insert the dynamic effect.
Press the F3 (
SELECT
) button to select the effect that
you want to insert. Press the F4 (
ON/OFF
) button to set
the selected effect to
ON
and insert it.
You can also align the cursor with
INSERT EFFECT
on
the Mixer screen and use the JOG/DATA dial to turn the
effect on/off.
Adjusting dynamic effects
You can edit the parameters of the selected dynamic
effect. The parameters differ depending on the effect
type.
Use the CURSOR (5/b/g/t) buttons to select the
parameter that you want to change, and then use the
JOG/DATA dial to set the value.
NOTE
There is no preset or library function for dynamic effects.