QuickLabel Kiaro! - Manual (Page 89)

Kiaro! Maintenance Utility
Kiaro! User Guide 73
Setting the Cut and Stop Positions
The Cut Position and Stop Position settings adjust the position at which the media is
fed after printing.
• If you are using an optional cutter, media is fed based on the Cut Position setting.
• If you are not using an optional cutter, media is fed based on the Stop Position
setting.
1 Launch the Kiaro! Maintenance Utility.
From the Windows Start Menu, choose Start > All Programs > QuickLabel
Kiaro! > Kiaro! Maintenance Utility . A language and printer prompt will open.
Select a display language and the Kiaro! printer you want to connect to. Choose
OK .
2 Choose the Position tab.
3 To read the cut position and stop position values from the printer and set the Cut
Position and Stop Position controls accordingly, choose Read From Printer .
4 Enter a cut position value. This value will be used when an optional cutter is
attached.
• Positive values result in more media being fed after printing before the media
stops.
• Negative values result in less media being fed after printing before the media
stops.
You can adjust the cut position -10 to +10 mm.
5 Enter a stop position value. This value will be used when an optional cutter is not
attached.
• Positive values result in more media being fed after printing before the media
stops.
• Negative values result in less media being fed after printing before the media
stops.
You can adjust the stop position -10 to +121 mm.
6 To save the cut position and stop position values, choose Save to Printer .