QuickLabel Kiaro! - Manual (Page 67)

Designing and Printing Labels
Kiaro! User Guide 51
3 If necessary, you can select a printing orientation. Orientation is often set within
the design application. However, if you cannot select an orientation in the design
application, choose from the following options:
• Portrait - Select this option if you want to print the label in a portrait
orientation on the label roll.
• Landscape - Select this option if you want to print the label in a landscape
orientation on the label roll.
4 If necessary, you can rotate the printed image 180 degrees by choosing Rotate 180 .
5 If necessary, you can print the image in a mirrored orientation by choosing Mirror
Image .
6 If necessary, you can select a printing quantity. Print copies are specified within
the application before printing. However, you can override that value here, or use
this setting if the application does not provide a setting.
If you enable the Always Use Driver Setting option, the print quantity you specify
in the driver will override the print quantity specified in your design application.
7 If necessary, you can change the print speed. However, the Auto print speed is
recommended. This option automatically adjusts printing speed based on the
speed of the print job data received by the printer.
When the printer does not have enough data it will stop printing, wait for the
required amount of data, then retract media to the next label and resume printing.
If automatic speed is used, printing will continue at a slower speed. If a specific
speed is selected, printing will continue at the same speed.
8 If your Kiaro! printer has the auto-cutter accessory installed, you can set up the
cutter.
• Check the Cutter Enabled option to enable the auto-cutter.
• Use the Labels Between Cut field to indicate the number of labels to print
between each cut.
The minimum cut length is 1.496 inches (38 mm). If you choose to cut between
each label, and the label length is shorter than the minimum cut length, the
label will print and be advanced an additional label length plus 0.25 inches
(6.35 mm) and then cut.
9 Choose OK .