QuickLabel Kiaro! User Manual
Page 142
RW-5 Rewinder
126
Kiaro! User Guide
3
Insert the tabs from bracket U into the slots on bracket R. These two brackets will
later be used to position the Kiaro! printer.
4
Fasten the R-U bracket to the R bracket using the supplied thumb nuts. Ensure the
threaded pin is centered in the adjustment slot.
Note: These thumb nuts may need to be loosened at a later time when aligning labels
during rewinding.
5
Fasten the RW-5 rewinder to the R-U bracket using the supplied thumb screws.
Note: These thumb screws may need to be loosened at a later time when aligning labels
during rewinding.
6
Use the Moving feature in the Kiaro! Maintenance Utility. This utility will prepare
the printer for lifting and moving onto the brackets. Preparing for Moving
7
Holding the handles at the bottom of the printer, lift the printer and then place it
on the connected R and U brackets. Lift from the illustrated points. Do not hold the
front side of the printer. Ensure the printer remains level as you move it.