QuickLabel Kiaro! - Manual (Page 153)

UW-5 Unwinder
Kiaro! User Guide 137
12 Feed the media under the dancer arm and up into the entry slot on the rear of the
printer. The media path is illustrated below.
As the dancer arm is lifted, the mandrel will unwind and feed media as needed.
Do not turn the unwinder mandrel by hand to advance the media. If you need to
advance the media, lift the dancer arm slightly.
13 Insert media along the left-side guide under the transport guide (left) until it stops
at the roller in the feeder slot.
Media at the roller in the feeder slot is automatically pulled in slightly.
14 If the media is not squarely aligned in the feeder slot, adjust the position of the
unwinder as needed.
• Loosen the thumb screws that fasten the UW-5 unwinder to the R-U bracket.
Slide the unwinder left/right as allowed by the adjustment slots until the
media is squarely aligned in the feeder slot. Then tighten the thumb screws.
• If a greater adjustment range is needed, loosen the thumb nuts that fasten the
R-U bracket to the U bracket. Slide the unwinder left/right as allowed by the