QuickLabel Kiaro! - Manual (Page 44)

Quick Start Guide
28 Kiaro! User Guide
Systems, and will not cause any of the problems listed in these messages.
1 Ensure the printer is powered on and connected to the network via a LAN cable.
2 Obtain the installer package from the QuickLabel Systems web site. Launch the
installer to open the installation wizard. Choose
Next .
3 Use the driver installation wizard to install the driver. Refer to the following
information during this process.
• Choose the Ethernet connection method when prompted.
• Allow the installer to access the network if prompted.
• Choose the Kiaro! printer in the printer list when prompted. Alternately, you
can choose to find a specific printer by IP address or MAC address.
• Configure the printer for DHCP or a static IP address.
Ensure the printer has been in the “Ready” state for at least 30 seconds before
attempting to connect via DHCP or static IP address. Additionally, if you
change the selection from static IP address to DHCP, wait at least 30 seconds
before proceeding to allow the printer to establish DHCP communication.
• Select an installation location for the Kiaro! Maintenance Utility when
prompted.
Choose Finish in the installation wizard after successfully installing the Kiaro!
Maintenance Utility and driver.