QuickLabel Kiaro! - Manual (Page 104)

Kiaro! Maintenance Utility
88 Kiaro! User Guide
5 Determine if you are using matrix-in or matrix-out media. The next action will
vary based on whether the matrix is intact or removed.
• Matrix-In - If your media has die cuts and the matrix has been left intact, no
further preparations are needed. Please proceed to the next step.
• Matrix-Out - If your media has spaces between each label resulting from the
removal of the matrix during the die cutting process, remove 160mm (6.5
inches) of label material from the end of the media roll.
This process improves sensor accuracy by allowing a small portion of the label
liner to advance through the printer before any label material is introduced.
6 Reload the label roll into the printer and close the roll cover.
7 Press and hold the FEED key on the printer control panel. Release the key when a
label starts exiting the front of the printer.
8 Choose Save Calibration in the Top of Form Calibration window.
9 Choose Close .
Adjusting the Top-of-Form Threshold
If any of the following errors occur while using reflective mark media, you may need
to calibrate the top-of-form sensor threshold. The following table describes the types
of adjustments needed for each error condition.
Error # Error Name
Sensor Adjustment
Adjust-
ment Value Internal Cutter
1002 No paper Increase NA +0.2V
1102 Paper length is too short Increase NA +0.2V
1104 Paper length is too short NA Increase +0.2V
1301 Paper jam occurred Decrease NA -0.2V