Microcom 814M Programming Manual - Manual (Page 78)

74
1B 63 38 00 (select PRST action mode)
1B 53 (switch to standard mode)
33 33 33 33 33 20 49 6E 20 73 74 61 6E 64 61 72 64 20 6D 6F 64 65 2E 20 54 68 65 20 70 61 70 65 72 20 69
73 20 63 6F 6E 74 69 6E 75 6F 75 73 2E 20 54 68 65 20 70 72 65 73 65 6E 74 65 72 73 20 69 6E 20 72 65 74
72 61 63 74 69 6F 6E 20 6D 6F 64 65 21
0A (print)
1D 56 00 (cut paper)
After transmits the above command, then
Printout:
33333 In standard mode. The paper is continuous. The presenters in
retraction mode!
PRST action: After printing and cutting, the PRST presents out the printed paper and waits for
the user to take it away. If the printout is not taken away within 4 seconds, the PRST retracts
the paper into a waste bin.
2) Select marked paper, page mode and PRST ejection mode.
0A (set the print starting position to the beginning of the line)
1B 40 (initialize printer)
1B 63 30 02 (select black mark paper)
1B 63 39 04 (set PRST waiting time)
1B 63 38 02 (set PRST action mode)
1B 4C (switch into pager mode)
1B 57 00 00 00 00 80 02 00 04 （select print area）
33 33 33 33 33 20 49 6E 20 70 61 67 65 20 6D 6F 64 65 20 61 6E 64 20 74 68 65 20 70 61 70 65 72 20 69 73
20 62 6C 61 63 6B 20 6D 61 72 6B 20 70 61 70 65 72 20 74 68 65 20 70 72 65 73 65 6E 74 65 72 20 69 73 20
69 6E 20 65 6A 65 63 74 69 6F 6E 20 6D 6F 64 65 21
0C
（ print）
1D 56 00
（ cut paper）
After transmits the command, then
Printout：33333 In page mode and the paper is black mark paper the presenter is in ejection
mode!
PRST action: After printing and cutting, the PRST presents out the printed paper and wait until the
user takes it away.
4.3 Programming examples
In this paragraph, the most commonly used commands are outlined below (Refer to 2. command set for
detailed usage). The general programming approach followed by programmers is “initialization－>set
printing and print data－>print and present printout－>status check”, read descriptions below carefully for
quickly mastering this approach.
4.3.1Initialization
1) Initialize printer :1B 40.
2) Select paper type :1B 63 30 n, n = 0 (continuous paper)； n = 2（black mark paper).