Microcom 814M Programming Manual User Manual
Page 51
47
[Notes]
[Reference]
♦ y specifies the number of dots in the vertical direction.
The number of dots in the horizontal direction is x × 8, in the vertical direction it is y ×
8.
If x × y is out of the specified range, this command is disabled.
The maximum capacity for bit-images in RAM is 16K bytes.
The execution of ESC & command will erase the bit-images in RAM downloaded with
this command.
The d indicates bit-image data. Data (d) specifies a bit printed to 1 and not printed to
0.
The downloaded bit image definition is cleared when printer is reset or the power is
turned off.
The number for the bit-image downloaded is defined by GS # command.
The following figure shows the relationship between the downloaded bit image and
the printed data.
GS /
GS / m
[Name]
[Format]
[Range]
[Description]
Print downloaded bit image
ASCII
GS
/
m
Hex
1D
2F
m
Decimal 29
47
m
0 ≤ m ≤ 3, 48 ≤ m ≤ 51
Prints a downloaded bit image using the mode specified by m.
m selects a mode from the table below:
203DPI:
m
Mode
Vertical Dot Density
(DPI)
Horizontal Dot
Density (DPI)
0, 48
Normal
203
203
1, 49
Double-width
203
101
2, 50
Double-height
101
203