Microcom 814M Programming Manual User Manual
Page 30
26
[Reference]
-
Set right-side character spacing: ESC SP
-Select default line spacing: ESC 2, ESC 3
The following commands are enabled only to set in standard mode.
-Set printing area in page mode: ESC W
-Select print direction in page mode: ESC T
The following commands are ignored in standard mode.
-Set absolute vertical print position in page mode: GS $
-Set relative vertical print position in page mode: GS \
Standard mode is selected automatically when the printer is reset, or command ESC
@ is used.
FF, ESC FF, ESC L
ESC T n
[Name]
[Format]
[Range]
[Description]
[Notes]
Select print direction in page mode
ASCII
ESC
T
n
Hex
1B
54
n
Decimal 27
84
n
0 ≤ n ≤ 3
48 ≤ n ≤ 51
Selects the print direction and starting position in page mode. n specifies the print
direction and starting position as follows:
When the command is input in standard mode, the printer executes only internal
flag operation. This command does not affect printing in standard mode.
This command sets the starting position where data is buffered within the printing
area.
Parameters for horizontal or vertical motion units (x or y) differ as follows,
depending on the starting position of the printing area:
-If the starting position is the upper left or lower right of the printing area, data is
buffered in the direction perpendicular to the paper feed direction:
Commands using horizontal motion units: ESC SP, ESC $, ESC \
Commands using vertical motion units: ESC 3, ESC J, GS $, GS \