Microcom 814M Programming Manual User Manual
Page 36
32
ESC c 4 n
[Name]
Select paper sensor(s) to stop printing
[Format]
ASCII
ESC
c 4 n
Hex
1B
63 34 n
Decimal
27
99 52 n
[Range] 0 ≤ n ≤ 255
[Description] Selects the paper sensor(s) used to stop printing when a paper-end is detected,
using n as follows：
Bit
0/1
Hex
Decimal
Function
0
00
0
Paper roll near end sensor disabled
0
1
01
1
Paper roll near end sensor enabled
0
00
0
Paper roll near end sensor disabled
1
1
02
2
Paper roll near end sensor enabled
2-7
Undefined
[Notes] • When either bit 0 or 1 is on, the printer selects the paper roll near-end sensor. When the paper roll
sensor detects a paper-end, the printer goes off-line after current printing stops.
[Default]
n = 0
ESC c 5 n
[Name]
[Format]
[Range]
[Description]
[Notes]
[Default]
Enable/disable panel buttons
ASCII
ESC
c 5 n
Hex
1B
63 35 n
Decimal 27
99 53 n
0 ≤ n ≤ 255
Enables or disables the panel buttons.
♦ When the LSB of n is 0, the panel buttons are enabled.
♦ When the LSB of n is 1, the panel buttons are disabled.
Only the LSB of n is valid.
When the panel buttons are disabled, none of them are usable.
In the macro ready mode, the panel buttons are always enabled.
n = 0