Microcom 814M Programming Manual User Manual
Page 59
55
GS V m GS V m n
[Name]
[Format]
[Range]
[Description]
[Notes for and ]
[Note for ]
Select cut mode and cut paper
ASCII
GS
V
m
Hex
1D
56
m
Decimal
29
86
m
ASCII
GS
V
m n
Hex
1D
56
m
n
Decimal
29
86
m
n
m = 0, 48
m = 66, 0 ≤ n ≤ 255
Selects a mode for cutting paper and executes paper cutting. The value of m
selects the mode as follows:
M
Print mode
0,48
Full cut
66
Feeds paper (n × vertical motion unit) inches and cuts the paper fully.
This command is only effective when processed at the beginning of a line.
When m = 0 or 48, if the paper feed length (L1) is less than the minimum page
length (L
m
) specified when executing this command, the printer feeds paper
(L
m
-L1) long and cuts paper. Otherwise, the printer cuts paper directly.
When m = 66, the printer feeds paper (n × vertical motion unit
)
first
.
If the total
paper feed length (L2) is less than the minimum page length (L
m
) specified
when executing this command, the printer feeds paper (L
m
-L2) long and cuts.
Otherwise, the printer cuts paper directly.
The horizontal and vertical motion units are specified by GS P.
The vertical motion unit (y) is used for calculating the paper feed length.
In marked paper mode cutting position is set with mark and cut paper.
GS W nL nH
[Name]
[Format]
[Range]
[Description]
Set printing area width
ASCII
GS
W
nL nH
Hex
1D
57
nL nH
Decimal 29
87
nL nH
0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
Sets the printing area width to the area specified by nL and nH.
The printing area width is set to [(nL + nH × 256) × horizontal motion unit]] inches.