Microcom 814M Programming Manual User Manual

Page 74

FS S n1 n2

[Name] Set the right and left character spacing

[Format]

ASCII

Hex

Decimal 28

[Range]

0 ≤ n1 ≤ 255

0 ≤ n2 ≤ 255

[Description] Set the right spacing and the left spacing to n1 and n2 respectively.

• The left spacing is [n1 × horizontal or vertical motion unit] inch, and the right spacing is [n2

×horizontal or vertical motion unit] inch.

[Notes] • When double-width is set, the right and the left spacing is doubled.

• In standard mode, the horizontal motion unit is used.

• In page mode, it is depending on starting position of the printable area as follows：

- When the starting position is set to the upper left or lower right, the horizontal motion unit

is used.

- When the starting position is set to the upper right or lower left, the vertical motion unit is

used.

- The maximum spacing of Chinese character is 36 mm, all setting exceeding the

maximum is converted to the maximum automatically.

[Default]

n1 = 0, n2 = 0