Microcom 814M Programming Manual - Manual (Page 15)

11
ESC SP n
[Name]
[Format]
[Range]
[Description]
[Notes]
[Default]
[Reference]
Set right-side character spacing
ASCII ESC SP n
Hex 1B 20 n
Decimal 27 32 n
0 ≤ n ≤ 255
Sets the character spacing for the right side of the character to [n × horizontal or vertical
motion units] inches.
ƒ The horizontal and vertical motion units are specified by GS P.
ƒ Without setting right-side character spacing, only changing the horizontal or vertical
motion unit does not affect the current right-side spacing.
ƒ The right-side character spacing for double-width mode is twice the normal value.
When characters are enlarged, the right-side character spacing is enlarged
accordingly.
ƒ This command sets values independently in each mode (standard and page modes).
ƒ In standard mode, the horizontal motion unit is used.
ƒ In page mode, the horizontal or vertical motion unit is specified depending on starting
position of the printable area as follows:
1 When the starting position is set to the upper left or lower right of the printable
area using ESC T, the horizontal motion unit (x) is used.
2 When the starting position is set to the upper right or lower left of the printable
area using ESC T, the vertical motion unit (y) is used.
ƒ For 300DPI printers, the maximum right-side spacing is 288/305 inches. Any setting
exceeding the maximum is converted to the maximum automatically.
ƒ For 203DPI printers, the maximum right-side spacing is 288/203 inches. Any setting
exceeding the maximum is converted to the maximum automatically.
n = 0
GS P