Microcom 814M Programming Manual - Manual (Page 37)

33
ESC c 8 n
[Name]
[Format]
[Range]
[Description]
[Notes]
[Reference]
Select PRST action mode
ASCII ESC c 8 n
Hex 1B 63 38 n
Decimal 27 99 56 n
0 ≤ n ≤ 3
Selects PRST action mode specified by n as follows.
N PRST action mode
0 Retraction mode
1 Ejection mode(special model)
2 PRST holding waiting mode
3 PRST disabled mode
Printer operates after receiving command, then if PRST is enabled, proceed as follows:
ƒ During printing, the PRST starts and hold the paper head. The PRST will
accommodate the printout and hold the end of paper after the printing is finished. After
the waiting time, the PRST operates as follows:
1) In retraction mode, retract the printout into a waste-bin, after reach a
setting time. Its main purpose: user doesn’t take it away in specified time,
and avoid pollution and keep secrecy for customers.
2) In ejection mode, discharge the printout after reach a setting time. Its main
purpose: If user doesn’t take paper away in specified time, it discharges for
next printout.
3) In waiting mode, wait until the user takes the printout away after a setting
time.
ƒ If the PRST is disabled, it takes no actions during printing and after printing. It is
recommended to remove the PRST to prevent from paper jam if the PRST function is
not desired.
ƒ ESC c 9 can set the waiting time before action of PRST.
ƒ ESC c 9