Microcom 814M Programming Manual User Manual
Page 38
34
ESC c 9 t
[Name]
[Format]
[Range]
[Description]
[Notes]
[Reference]
Set PRST waiting time
ASCII
ESC
c 9 t
Hex
1B
63 39 t
Decimal 27
99 57 t
0 ≤ n ≤ 240
Sets the time period (t in seconds) for PRST to wait before it takes any actions set by
ESC c 8.
Actions here mean the PRST action modes specified in ESC c 8 command
ESC c 8
ESC c @ n
[Name]
[Format]
[Range]
[Description]
[Notes]
[Reference]
Enable/disable real-time commands
ASCII
ESC
c @ n
Hex
1B
63 40 n
Decimal 27
99 64 n
0 ≤ n ≤ 255
Enables or disables the real-time commands.
♦ When the LSB of n is 0, the real-time commands are disabled.
♦ When the LSB of n is 1, the panel buttons are enabled.
Only the LSB of n is valid.
When the printer is turned on, the real-time commands are always enabled.
When error occurs, the real-time commands are automatically enabled.
DLE EOT n
ESC c I
[Name] PRESENTER retract immediately
[Format] ASCII ESC
c
I
Hex
1B
63
49
Decimal 27
99
73
[Description] PRESENTER retract the paper immediately
[Notes] This command does not change the waiting time of PRESENTER.
[Reference] ESC c 8