Microcom 814M Programming Manual User Manual

Page 28

[Reference]

This command sets the position where data is buffered to the position specified by

ESC T within the printing area defined by ESC W.

This command switches the settings for the following commands to those for page

mode:

Set right-side character spacing: ESC SP

Select line spacing: ESC 2, ESC 3

Only value settings is possible for the following commands in page mode; these

commands are not executed until switch to standard mode.

Turn 90° clockwise rotation mode on/off: ESC V

Turn upside-down printing mode on/off: ESC {

Set left margin: GS L

Set printable area width: GS W

The printer returns to standard mode, after it is reset, or executes ESC @.

FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS $, GS \

ESC M n

[Name]

[Format]

[Range]

[Description]

[Notes]

Select character font

ASCII

ESC

Hex

Decimal 27

n = 0, 1, 2, 3, 48, 49, 50, 51

Selects character fonts.

N Function

0,48

Select standard ASCII font

1,49

Select compressed ASCII font:

2,50

Select user defined character

3,51

Select Chinese font, include:

1) Simplified

Chinese（GB2312）

2) Traditional

Chinese（BIG5）

3) Japanese

(JIS/SJIS/EUC)

4) Korean

(KSC5601/EUC)

The printer will print selected Chinese font [simplified Chinese, traditional

Chinese, Japanese (EUC) or Korean (EUC)] according to its configuration

• When Chinese font is selected, Chinese font and western font can be printed

together. The font code in <20>H~H is identified as Western font

automatically, and those in H~ are Chinese font.

• When Japanese is selected, the command switches western font to

Japanese.

• After Chinese font is selected, Font A is also enabled automatically.