Metric Halo 2882 operating guide - Manual (Page 66)

Mobile I/O User’s Guide
58
S ETTING UP THE ROUTING
The first thing we need to do is configure our mixers and routing. For this
setup we will use two mixers in MIO Console: one for the actual headphone
mix and one for the send mix to the reverb. To do this we need to bring up
the Mix/Output Routing view in MIO console:
In its default state, the WIDE mixer is configured with only the Analog Inputs
assigned to the mix busses, so we need to add the ADAT inputs. To do this
we simply click in the assign tiles under the ADAT inputs for the mix busses
we want. For this example we will use for the stereo headphone mix and
mix busses 3 and 4 for the send mix.
Figure 42: Configuring the Matrix
Figure 43: Naming the mix busses