Metric Halo 2882 operating guide - Manual (Page 103)

Mobile I/O User’s Guide – Appendicies
95
Installing a firmware update
In order to install a firmware update, follow these steps:
1. If there is an associated driver update, place the MobileIO Driver
and MobileIO Enabler in your extensions folder inside your system
folder.
2. Reboot your computer.
3. Make sure your Mobile I/O is powered up and connected to your
computer.
4. Double click on MIOBootInstaller.
You will see the following:
MIOBootInstaller will find your Mobile I/O on the FireWire bus and begin
sending commands to it. When MIOBootInstaller is finished updating the
Figure 65: MIO Package
Figure 66: MIOBootInstaller Window