Metric Halo 2882 operating guide - Manual (Page 42)

Mobile I/O User’s Guide
34
nels 1-8 and digital output channels 1-2, going from left to right. Please note
that when the box is clocking at 2x rates (88.2-96k), the ADAT output uses
pairs of optical channels to transport the audio and only channels 1-4 will
show activity, channels 5-8 will not display signal. Both channels of the ste-
reo digital output remain active at all sample rates.
B OX I NFO
The Box Info section of the panel, in the lower right-hand corner of the win-
dow, shows you information about the currently connected and selected
Mobile I/O unit. This section displays the Serial Number, Model Information
and Firmware revision of the connected box. All of this information can be
useful in trying to track down any connection problems that may arise.
If there is no information displayed in the Box Info section, the software is
not communicating properly with the Mobile I/O hardware, or there is no
Mobile I/O present on the FireWire bus.
If the FireWire light on the front panel of the Mobile I/O is illuminated but
the box information does not appear in the console window, it is very likely
that the software has not been installed properly. If this is the case, please
refer to the installation instructions for details on how to properly install the
software. Also, pleaseensure that there are no copies of the MobileIO Driver
Figure 31: Box Info