Measurement Computing WavePort rev.3.0 - Manual (Page 55)

WavePort User’s Manual 09-29-00 WaveView 6-3
• If the above fail, a dialog box appears, providing you with certain options. These are:
Retry, Select Device, Load File, and Exit. (See following figure).
WaveView StartUp Box
Reference Note:
Refer to page 8-2 of the Troubleshooting Chapter for advice regarding connection problems.
• If no user-configuration file is found, or if no communication established, a dialog box prompts you
to choose an actual WaveBook from the device inventory, or to select a simulated device.
Select Device Box
Simulated WaveBook. If the hardware is not available, or if you just want to practice using the software,
select Simulated Device. The Simulated Device allows you to run various software functions with no
hardware concerns.
The Simulated mode is also available from WaveView’s pull-down menu. To select the simulated mode:
1. Choose Select Device from the System pull-down menu.
2. Select Simulated Device from the Available Devices list.
WaveBook Attached. If the WaveBook hardware is connected and switched on, select the applicable
WaveBook device. Then click on the Properties button to view the Device Properties screen (see following
figure).