Measurement Computing WavePort rev.3.0 - Manual (Page 128)

WavePort/V Specifications
10-6 Specifications 09-29-00 WavePort User’s Manual
External Clock
Connector: Available on DB25 digital input
Input Signal Range: 5V TTL compatible
Input Characteristics: 50K ohms pull up (to +5V) in parallel with 50pF
Input Protection: Zener clamped –0.7 to +5V
Delay: 200ns
Signal Slew Rate Requirement: 20V/us minimum
Rate: Up to 1MHz
Divisor ratio: Divide by 1 through 255, selectable
Clock Counter Accuracy: <0.02% error
Clock Counter Range: 0.01Hz to 100KHz
Sequencer
Operation: Programmable for channel, gain, and for unipolar/bipolar range in random order
Depth: 128 location
Channel-to-Channel Rate: 1.0-1.1us/channel, all channels equal
Maximum Repeat Rate: 1MHz
Minimum Repeat Rate: 100 seconds per scan
Expansion Channel Sample Rate: Same as on-board channels
High-Speed Digital Inputs/General-Purpose Outputs
Connector: DB25 Female
Configuration:
16 TTL-compatible pins, selectable for input or output
Input Characteristics: TTL-compatible
Output Characteristics: ALS TTL output in series with 33 ohms
Output Updates: Outputs may be changed via program control
Input/Output Protection: Diode clamped to ground and +5V
General Specifications
Warm-up: 30 minutes to rated specifications
Environment:
Operating: -10 to +55°C, 0-95% RH (non-condensing)
Storage: -40 to 70°C
Power Consumption: 100W max. plus Notebook Power utilized (50W max.)
AC Power Input Range: 100-240VAC (90-260VAC allowable), 50-400Hz
DC Power Input Range: 12-30VDC
Charging Time: 5 hours to maximum charge (operating from AC input, modules off)
Battery Backup Life: 30 minutes
Vibration: Tested to MIL Std 810E Category 1 and 10
Dimensions: 470mm wide X 369mm deep X 191 mm high (18.5” X 14.5” X 7.5”)
Weight: 15kg (33 lbs)
Included Accessories and Software
Software: WaveView
DIAdem-View
DOS and Windows Drivers
LabView Drivers
Hardware: CA-1, IEC Power Cable
CA-198 5-pin DIN to vehicle cigarette lighter power cable, 10ft (3.048 m)
CA-35-2 Parallel Port Cable
HA-192 Accessory Pouch
48” (1.2m) of ST-5-6, Tape, Adhesive Foam Seal
2-10” (0.254m) of ST-27, Dual-Lock Fastener with Adhesive