Measurement Computing WavePort rev.3.0 - Manual (Page 21)

WavePort User’s Manual 06-14-00 System Setup 3-3
(5) Push firmly down on the Notebook to ensure the
adhesive makes good contact. The Notebook should
now be adequately secured to WavePort’s cover plate.
The Notebook PC can now be easily removed from
WavePort, and easily re-attached.
After securing the Notebook PC to the cover plate
you should add four foam strips to the inside of
WavePort’s hinged lid. Cut the strips as needed to
form a rectangle on the Notebook’s cover (see the
figure following the Caution).
CAUTION CAUTION CAUTION CAUTION
Forcing WavePort’s cover to close on a Notebook PC that exceeds the height restriction
of 1.5” (38 mm) is likely to result in damage to the Notebook PC.
How to use foam strips (part no. ST-5-6) to pad your Notebook PC.
1. Verify that the Notebook PC does not exceed a height (when the PC is closed) of 1.5 inches (38 mm). Notebook’s
exceeding this dimension can be damaged when closing WavePort’s cover.
2. Place four foam strips on the cover of the Notebook PC. The adhesive-side faces the WavePort’s hinged cover.
3. Fully close, then reopen WavePort’s cover.
4. Verify that the foam strips are attached firmly to WavePort’s cover.