Measurement Computing WavePort rev.3.0 - Manual (Page 34)

4-6 Hardware and Operation Reference 09-29-00 WavePort User’s Manual
WavePort/PE8
WavePort/PE8 can measure up to eight channels of voltages within ±10V; and up to 8 channels of ICP ® transducer excitation.
The unit receives its channel-input signals through two columns of eight BNC connectors (16 channel inputs total). The
columns are labeled MODULE 1 and WAVEBOOK. In addition to the channel-input BNCs, WAVEBOOK contains a BNC
for PULSE Trigger Input, and MODULE 1 include one BNCs for filter clock input (FILTER CLK. IN), and another BNC for
EXCITATION SOURCE OUT (see following figure).
The signal panel includes a DB25 connector for DIGITAL I/O, EXT CLOCK (external clock), and TTL TRIGGER.
Connection nodes for CHASSIS (ground) and ANALOG COMMON are also provided.
WaveBook
Analog Inputs
CH1 through CH8, Analog Inputs via
BNC Connectors.
• 16 bit resolution
• Software selectable for unipolar or
bipolar operation
• Unipolar Ranges
0 to +10V
0 to + 4V
0 to +2V
• Bipolar Ranges
±10V, ±5V, ±2V, ±1V
• Maximum Overvoltage: ±30 VDC
DC-Coupled Only,
Fully Differential
See Chapter 6, WaveView and
Chapter 10, Specifications for
additional information.
Module 1
Dynamic Signal Conditioning
CH1-1 through CH1-8
• Gain Ranges:
x1, 2, 5, 10, 20, 50, 100, and 200
• Input Ranges:
5V, 2.5V, 1V,
500 mV, 250 mV,
100 mV, 50 mV,
and 25 mV peak
AC-Coupled Only,
BNC shells are analog common.
See Chapter 6, WaveView and
Chapter 10, Specifications for
additional information.
Filter Clock In
(See page 4-4)
Excitation Source Out
(See page 4-4)
Chassis Ground
(See page 4-10)
Pulse Trigger Input (see page 4-13)
• Input Signal Range: ±5V
• Input Characteristics: 75 Ω
• Input Protection: ±10V max.
• Minimum Pulse Width: 100 ns
• Maximum Pulse Width: 0.8 sec
• Latency: 300 ns
Digital I/O (see page 4-11)
External Clock (see page 4-11, 15)
TTL Trigger (see page 4-11)
Analog Common (see page 4-10)
WavePort/PE8 Signal Panel
Reference Notes:
Additional information regarding WavePort/PE signal connections appears elsewhere in this manual.
WavePort/PE16 information appears on the previous page. Chapter 6, WaveView, includes information
regarding channel configuration. Maintenance, intended environment, and transportation issues are discussed
in chapter 9. Specifications are provided in chapter 10.