JLCooper FaderMaster Pro - Manual (Page 7)

DOWN
Steps back down through memory banks.
For example, if the display says
P 2,
Press DOWN, display then says P 1.
Hold DOWN while moving any fader to quickly access any
bank.
NULL (SHIFT)
Holding NULL while moving a fader allows you to move the
fader without any MIDI data being sent. This allows you to pre-
position the fader to start at a specific MIDI value.
NULL is also used in the A Banks along with the NULL LEDS, to
avoid unexpected jumps in level while editing a mix.
Observe the NULL LEDs to determine if the fader needs to be
raised or lowered to match previously recorded MIDI data.
The NULL (SHIFT) button also accesses SHIFTED functions.
These are indicated in blue legends on the front panel.
UP
Steps up through memory banks.
For example, if the display says
P 1,
Press UP, display then says P 2.
Hold UP while moving any fader to quickly access any bank.
MODE (that is, SHIFT and UP)
In the Automation Banks, selects what the buttons above the
faders do. These buttons are either "Enables" or "Mutes".
Press an Enable to turn a fader on or off.
Press a Mute to send a MIDI Controller with a zero value.
The current function of the buttons is indicated by a dash in
the seven-segment display next to the word ENABLE or MUTE.
7